1MRK000173-BCR00
Protection-System Control Circuit Board - Protection Control PCB Assembly
Lifecycle note: Use the unit nameplate and current ABB documentation as final references before approving a replacement.
Product Condition
Original New with One Year WarrantyParts Available
In Stock and Same Day ShippingDelivery Mode
Shipping via DHL Fedex or UPS etcEmail:
sales17@amikon.cnWhatsapp/Mob:
+86 15359408275Protection-System Control Circuit Board - ABB Protection and Control Hardware
ABB 1MRK000173-BCR00 is a protection control circuit board for compatible ABB substation or industrial protection hardware. The BCR00 suffix identifies the required board variant.
Board replacement should preserve the original connector mapping, chassis position and interaction with companion electronics. Electrical characteristics and supported functions must be confirmed from the exact host-system documentation.
Use ESD-safe handling, inspect the backplane and connectors and document all jumpers before removal. Complete the host self-test and application-specific protection checks after replacement.
| Manufacturer | ABB |
|---|---|
| Complete model | 1MRK000173-BCR00 |
| Product type | Protection Control PCB Assembly |
| System family | ABB Protection and Control Hardware |
| Complete model | 1MRK000173-BCR00 |
| Manufacturer | ABB |
| Functional class | Protection control board |
| Hardware suffix | BCR00 |
| Configuration check | Revision, slot, connectors and installed application |
ABB 1MRK000173-BCR00 is a protection control pcb assembly for compatible ABB protection and control hardware. It is a BCR00 circuit-board variant for the compatible ABB protection-system hardware.
ABB 1MRK000173-BCR00 provides board-level protection control and signal coordination in the matching ABB host assembly.
ABB 1MRK000173-BCR00 is used in ABB protection equipment that specifies the complete BCR00 hardware identity.
For ABB 1MRK000173-BCR00, verify supply, connector assignment, hardware revision, firmware dependency and host compatibility.
ABB 1MRK000173-BCR00 must match the original slot, backplane, companion modules and configured protection application.
Before replacing ABB 1MRK000173-BCR00, record the complete nameplate, board revision, slot, connectors, jumpers, cables and host-equipment identity.
Install ABB 1MRK000173-BCR00 using ESD-safe handling and the approved ABB service procedure, preserving connector keying, grounding, cable routing and the original board position.
A similar suffix must not replace ABB 1MRK000173-BCR00 until board layout, electrical interface, firmware, companion hardware and host-system compatibility are confirmed.
Provide ABB 1MRK000173-BCR00, all associated identifiers, hardware revision, host equipment, quantity, condition requirement, destination and clear nameplate photographs.
Send the complete model, revision, quantity, destination and nameplate photo so the exact hardware identity can be checked.
Visit us
32D Guomao Building, No.388, Hubin South Road, Siming DistrictDisclaimer : Salesplcauto sells new and surplus products and develops channels for purchasing such products. This website has not been approved or recognized by any of the listed manufacturers or trademarks. Salesplcauto is not an authorized distributor, dealer, or representative of the products displayed on this website. All product names, trademarks, brands, and logos used on this website are the property of their respective owners. The description, explanation, or sale of products with these names, trademarks, brands, and logos is for identification purposes only and is not intended to indicate any association with or authorization from any rights holder.
Copyright @2026 SalesPlc Limited. Sitemap
/ Blog
/ XML
/ Terms And Conditions
/ Privacy Policy
Network Supported